Re: z820 RAID configuration problem (1178 Views)
Reply
Occasional Visitor
Posts: 3
Registered: ‎01-09-2014
Message 1 of 6 (1,264 Views)
Accepted Solution

z820 RAID configuration problem

Hello,

I have a newly unboxed z820 workstation (running BIOS 3.52). I'd like to get my RAID configuration setup, but I am having problems following the steps outlined in the Maintenance and Service guide:

 

http://h20628.www2.hp.com/km-ext/kmcsdirect/emr_na-c03424977-1.pdf

 

Specifically, under the "Configuring system BIOS" section, after confirming RAID+AHCI is set for SATA Mode and Post Messages are enabled, Step 4 then says to enable "SATA RAID Option ROM Download". There is no such item under Device Options. I do see "SAS Option ROM Download", which is already enabled.

 

Also, after exiting the BIOS settings, there is no CTRL+C or CTRL+I option to enter RAID settings...

 

I have indeed verified that there are two functioning drives on the machine...

 

Anyone know what's up?

 

Thanks,

Jake

Respected Contributor
Posts: 270
Registered: ‎07-08-2009
Message 2 of 6 (1,259 Views)

Re: z820 RAID configuration problem

No Ctrl-I even after saving to RAID+AHCI and a reboot?

After a reboot, is it still RAID+AHCI?
Systems Administrator
(if my post was helpful, please "mark as a solution" or give "kudos" - thanks)
Occasional Visitor
Posts: 3
Registered: ‎01-09-2014
Message 3 of 6 (1,220 Views)

Re: z820 RAID configuration problem

Correct - CTRL-I does not launch the RAID Utility app. CTRL-I is not listed as an option (nor does pressing the key combination work). I have an older Z400 as well that is configured for RAID (where CTRL-I is listed and working), so I have some familiarity with when to expect the prompt (assuming nothing drastic has changed between these models over the past few years).

 

Also, the RAID+AHCI setting is persisting across reboots on this newer Z820 of mine.

 

Thanks,

Jake

Respected Contributor
Posts: 270
Registered: ‎07-08-2009
Message 4 of 6 (1,216 Views)

Re: z820 RAID configuration problem

It may also be disabled in "Boot Order" under Storage - checked there? If it's there, the next things I'd do:

- clear CMOS first, see what happens;
- then take our any PCIe devices in the system, leave only the boot drive on SATA (or SAS) 0, see if IRST prompt comes up.
- if it doesn't, it might be a good time to call HP support... :(
Systems Administrator
(if my post was helpful, please "mark as a solution" or give "kudos" - thanks)
Respected Contributor
Posts: 270
Registered: ‎07-08-2009
Message 5 of 6 (1,211 Views)

Re: z820 RAID configuration problem

Oh, and switch to legacy everything just for testing purposes - unless you've done it already.
Systems Administrator
(if my post was helpful, please "mark as a solution" or give "kudos" - thanks)
Occasional Visitor
Posts: 3
Registered: ‎01-09-2014
Message 6 of 6 (1,178 Views)

Re: z820 RAID configuration problem

Disabling secure boot and enabling legacy boot support did the trick! Thanks

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.