Re: Z1 workstation 2.5 dual drive assignments (183 Views)
Reply
Occasional Contributor
mikeproz
Posts: 2
Registered: ‎11-30-2012
Message 1 of 2 (209 Views)

Z1 workstation 2.5 dual drive assignments

i have a z1 workstation with 2 factory 2.5" SSD's (drives C & D). However, I'd prefer to replace 1 of the 2.5's with a larger capacity 2.5 SSD for just the D (or drive 1) drive. My question is when looking at the 2 identical drives in the carrier, how do I tell which one is D? Or must I remove each singly and see which one then fails to boot?

Please use plain text.
Occasional Advisor
blisterx1
Posts: 8
Registered: ‎10-26-2012
Message 2 of 2 (183 Views)

Re: Z1 workstation 2.5 dual drive assignments

Hello,

 

when you open the Z1 and look inside, then you will see in the HD compartment 2 SATA ports. The bottom one is SATA 0 and the  upper one is SATA 1. If you connect one of your 2.5 HD to the bottom connector then you can boot and have drive C.  The 2nd 2.5 HD will be connected to the upper SATA 1port and can be assigned as drive D.

It worked on my system. Hope it will help you.

Please use plain text.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation