04-21-2008 08:19 AM - last edited on 12-22-2013 07:43 PM by maikoro
I have an XW6600 with an LSI Logic 3041e controller card installed ... Two SAS Drives ... I have used the sas config utility to set up a raid 1 array. I run into problem when trying to install WinXP. I install the 3041e driver, let it load everything else, and I end up at a blue screen with stop error Stop 0x0000007B.
P.S. This trhead has been moved from Archived Desktops and Workstations to Workstations - z series, xw series, and legacy x and w series. - Hp Forum Moderator
04-23-2008 02:51 PM
04-24-2008 02:28 PM
04-24-2008 02:42 PM
This is the default SATA Emulation mode for the xw6600.
If you went into the BIOS and changed it, you might need the AHCI line. But I would leave it at the default.
A potential workaround would also be to set the SATA emulation to one of the IDE modes.
04-25-2008 01:48 PM
When you boot to your install media you are using the option rom/BIOS mechanisms to read the optical media.
During the installation, Windows needs the driver for the Mass Media controllers. The PATA optical drives use the in box Windows ATAPI driver. SATA optical drives (and hard drives) either need the SATA controller to be in an IDE emulation mode to use the in box ATAPI driver or you need to supply the SATA driver for Windows.