Raid Configuration and Performance (40 Views)
Reply
Highlighted
Occasional Contributor
Posts: 6
Registered: ‎12-24-2008
Message 1 of 1 (40 Views)

Raid Configuration and Performance

[ Edited ]

Perhaps someone can clarify the value of Raid 0, Striped Disk Array using a single disk controller.

In HP's Mini Whitepaper, "HP Workstations Raid Primer" (Doc.: c00786213.pdf), it states, "Using RAID 0 has potential for improved performance especially if drives are on different controllers."

My XW8600 has three HDs and one Optical drive hanging off the SATA controller. Will I gain any performance improvement in this case?

Alternately, would an improvement truly be realized using the SCSI drive controller for two Raid 0 drives?

 

 

P.S. This trhead has been moevd from Archived Desktops and Workstations Boards > Windows based to Workstations - z series, xw series, and legacy x and w series. - Hp Forum Moderator

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.