Raid Configuration and Performance (27 Views)
Reply
Occasional Contributor
KenPC
Posts: 6
Registered: ‎12-24-2008
Message 1 of 1 (27 Views)

Raid Configuration and Performance

[ Edited ]

Perhaps someone can clarify the value of Raid 0, Striped Disk Array using a single disk controller.

In HP's Mini Whitepaper, "HP Workstations Raid Primer" (Doc.: c00786213.pdf), it states, "Using RAID 0 has potential for improved performance especially if drives are on different controllers."

My XW8600 has three HDs and one Optical drive hanging off the SATA controller. Will I gain any performance improvement in this case?

Alternately, would an improvement truly be realized using the SCSI drive controller for two Raid 0 drives?

 

 

P.S. This trhead has been moevd from Archived Desktops and Workstations Boards > Windows based to Workstations - z series, xw series, and legacy x and w series. - Hp Forum Moderator

Please use plain text.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation