t5565z Manual update (400 Views)
Reply
Occasional Contributor
MarcVS
Posts: 3
Registered: ‎05-11-2007
Message 1 of 2 (400 Views)

t5565z Manual update

I have a client with 2 divisions.

 

The server with the HP Automatic Update Server services is located in one division (192.168.0.xxx). There is also the Terminal server.

In that division, everyrhing works fine. When I put a Thin Client in the network, it gets the profile.xml (Which hides the Configure Menu)

 

In the other division (192.168.1.xxx) the update server is not found (Broadcasting). I cannot make a DHCP Tag record, because the DHCP server is a WatchGuard firewall, which doens't know DHCP tagging.

So I enabled Manual Configuration. That worked... one time. The profile.xml was installed on the client. But when I restart the client it seems to forget the Manual Update, and again tries to update Automatic. What doesn't work...

 

What did I do wrong?

Occasional Visitor
gjimenez
Posts: 3
Registered: ‎08-31-2012
Message 2 of 2 (268 Views)

Re: t5565z Manual update

You must configure the profile.xml and set the manual update to 1

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.