IPSec Tunnel on SmartZero T510 - Help needed (95 Views)
Reply
Occasional Contributor
redfish
Posts: 2
Registered: ‎05-16-2013
Message 1 of 1 (95 Views)

IPSec Tunnel on SmartZero T510 - Help needed

Hello,

Is there any documentation on how to setup the IPSec tunnel on Smart Zero OS, I'm lost on what to put in the source and destination addresses in "General" and in the "Tunnel", where should I put the address of my security gateway ? What is the format of the addresses (can I put a netmask with a / for the destination network) how do I configure source address when it's a DHCP address (%any ?).

 

Any sample of a working configuration would help me a lot.

 

Thanks

 

Patrick

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.