03-13-2013 05:51 AM
We use SCCM R3, and i installed the HP imaging plug -in 1.1 I read the documentation, and it should be easy to deploy the standard HP t610 image, downloaded from the HP site..
The problem is that can't pre-configure the SCCM client
So i prefer to capture the image with SCCM..
I know that i need to configure some settings like SCCM client, the FBWF, probably adding NIC drivers to boot image, Administrator autoogon etc..
Is there a manual how to capture and deploy the T610 OS with SCCM???
03-18-2013 02:05 PM
The Imaging plug-in for HP Thin Clients can only be used to deploy images and has no capture facilities. You can however, capture a custom image using HP Device Manager or ThinState, and then deploy that image using the SCCM plug-in.
04-04-2013 03:37 AM - edited 04-04-2013 05:59 AM
Sorry for the late reply.
For now we have 2 Thinclients, and i don't want to use another tool like HP Device Manager to capture or deploy images. I like to use SCCM for this.
I found an article to deploy Wyse TC with SCCM, and i'm looking for a similar manual for the T610
I like to use PXE for deployment. Is it possible??
I'm looking into thinstate for capturing.. But all the the HP tools create a .IBR file. For SCCM i need a WIM file. So deployment would be only possible with HP plugin tools.. Correct??
04-12-2013 04:14 AM
I'm in the process of capturing an T610 image with HP thinstate. Only qiestion i have is about the SCCM client. Does thinstate prepare the SCCM client, or do i have to do it manually with CCuDELCert.exe tool??
11-27-2013 03:53 AM
is there any update on this. i would like to capture a WIM image to use deploying the thin clients with SCCM 2012, does anyone know the best way to do this?
11-27-2013 10:33 AM
I have now captured and deployed a T610 using sccm 2012 R2 mostly by following this guide
couple of things i missed initially, included in the guide...
during the capture:
You must disable the EWF, reboot then and also stop the service once its back up. i then went on to have problems due to a config manger client was already installed and out of date. i would suggest uninstalling it anyway by using the c:\windows\system32\ccmsetup\ccmsetup.exe /uninstall command on the client.
following the guide on creating a fresh task sequence and make sure that the partition is not set to use all the drive but 95% otherwise the install wont complete due to no room for the EWF.