05-19-2006 06:19 PM - last edited on 03-14-2013 07:28 PM by Maiko-I
I have rx2600 and a system borad of zx6000 (BMC 1.41).
The system board of rx2600 was broken, then I exchanged it for the system board of zx6000.
I installed Itanium2 900MHz 1.5MB L3 (SL67W), but the system did not boot.
Message is followings.
2 0 0x000063 0x0000000000000000 starting boot
0 0 0x000020 0x0000000000000000 CPU0 starting early config
0 0 0x00000E 0x0000000000010000 CPU0 at monarch selection
1 0 0x00000C 0x0000000000000000 CPU0 is the monarch
1 0 0x000261 0x0000000000000000 CPU0 present
0 0 0x000008 0x0000000000000000 starting cell config
0 0 0x00024B 0x0000000000000000 early platform check
0 0 0x000006 0x0000000000000000 current bus config register value
0 0 0x000044 0x0200000000200400 new bus config register value
Can anyone help?
P.S. This thread has been moved from Servers - Experts Online Now!!! > Itanium Based - Experts Online Now!!! to Workstations - Itanium-Based, hp9000, Visualize - HP Forums Moderator
05-22-2006 01:05 AM
05-23-2006 12:49 AM
Thank you for your advice. I disconnected the MP card and replaced the fans of rx2600 to those of zx6000. But the output from serial port on the system board is the same. System LED is blinking green and the fourth diagonostic LED is solid green though all fans are working.