Problem with monitor when booting up a C180 (72 Views)
Reply
Advisor
Gilles Cadrin_1
Posts: 19
Registered: ‎03-07-2001
Message 1 of 2 (72 Views)

Problem with monitor when booting up a C180

[ Edited ]

I have done a stupid thing...
I wanted to flash the firmware on a c180 from rev 2.7 to 6.1. According to the documentation of the firmware update, I had to use a serial connection to do the firmware due to a lock up issue with the keyboard.

So I interrupted the boot process, rediterected the PAth COnsole to serial_1.

since then, I can't see anything else when booting up. I have an FX addon card to the system with an HP 20inch monitor. The keyboard light doesn't flash.

How can I reset the console when booting up ?

When the Workstation comes up, I'm able to login to cde. The problem is just during the boot up process.

Thanks

 

P.S.Moved from Desktops and Workstations - Archived Desktops and Workstations Boards - general to Workstations - Itanium-Based, hp9000, Visualize

Trusted Contributor
Gerard Leclercq
Posts: 168
Registered: ‎05-26-1999
Message 2 of 2 (72 Views)

Re: Problem with monitor when booting up a C180

May we suppose you did not change the config at boot time from the terminal console to make the FX the boot console again?
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.