Re: HP 9000 715/64 Power Up sequence (898 Views)
Reply
Occasional Visitor
exstep
Posts: 1
Registered: ‎09-21-2011
Message 1 of 3 (907 Views)

HP 9000 715/64 Power Up sequence

Hi,

When I power up the 715/64 (HP-UX 9.X), the only thing that shows on the monitor was the function keys at the bottom of the screen. The function keys on the keyboard are working when I toggle it. Is there any way to display the power up sequence?

Thanks,

Terry

Please use plain text.
Acclaimed Contributor
Dennis Handly
Posts: 24,953
Registered: ‎03-06-2006
Message 2 of 3 (900 Views)

Re: HP 9000 715/64 Power Up sequence

Is there a "*" in the Remote Mode key?

Please use plain text.
Honored Contributor
Robert_Jewell
Posts: 1,234
Registered: ‎06-26-2001
Message 3 of 3 (898 Views)

Re: HP 9000 715/64 Power Up sequence

These go back, but I assume you mean you have a CRT monitor (not a terminal)?

 

This could mean your display path is not set properly.  When you power on the system do you get anything on the display at all?  If not, do you have an attached (and working) keyboard and mouse?  If I recall, without a key/mouse presence the output defaults to RS-232.

 

If you can get to the Boot Admin prompt, look for the path command to display the console path and try different options to get it right.

 

-Bob

Please use plain text.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation