A4576A Monitor problem ? (44 Views)
Reply
Occasional Visitor
Stephanie Bartlett
Posts: 2
Registered: ‎08-21-2000
Message 1 of 2 (44 Views)

A4576A Monitor problem ?

[ Edited ]

I am trying to hang an A4576A monitor from a B132L+ workstation running on board EG graphics and I am on my second monitor. The problem I am having is that each monitor I hooked up to the system shows a 5" patch of haze in the bottom right and left corners. I have tried automatic degaussing and manual degaussing with a wand and I still have this haze. Are the monitors all this way ? Do I need a higher rev of graphics ? The second monitor I tried worked perfectly from an older 735 system I have here.

 

 

P.S.This thread has been moved from Archived Desktops and Workstations Boards>general to Workstations - Itanium-Based, hp9000, Visualize- HP Forums Moderator

Please use plain text.
Trusted Contributor
Gerard Leclercq
Posts: 168
Registered: ‎05-26-1999
Message 2 of 2 (44 Views)

Re: A4576A Monitor problem ?

Hello,

This monitor should work on B132L+. As it does work on a 735, there can be a configuration problem.

At boot time, press the key TAB to select the correct configuration of the EG card.

Regards

Gerard Leclercq
Please use plain text.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation