V1910 switches VLAN and limited access to management (755 Views)
Reply
Occasional Visitor
pratproel
Posts: 1
Registered: ‎01-25-2011
Message 1 of 1 (755 Views)

V1910 switches VLAN and limited access to management

First I am a newbie at this. I have read the sections of the manual that I believe are applicable but to be frank the manual is lacking in specifics.

 

I have 3 V1910 series switches that I would like to configure as follows.

 

First switch, I will call it the Master,  I am using ports 1 and 2 as "stack ports". Ports 3 to 16 inclusive are on VLAN 5 and ports 17 to 24 are on  VLAN 10. On both of the other switches, Slave 1 and 2, all of the ports are on VLAN 5. So far everything is working but.......

 

I want only port 2 on Slave 1 and port 2 Slave 2 to be able to access the management pages. At the present time I can access the management pages from any port on Slave 1 and 2 but only from ports 3 to 16 on the master. I believe the problem is with way I have the VLAN interface setup but am not sure. I have created a VLAN interface for VLAN 5 but not VLAN 10.

 

Any help would be appreciated.

 

 

Please use plain text.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation