Link Aggregation Problem: "The port is not configured properly" on HP V1910-48G Switch (2108 Views)
Reply
Occasional Advisor
cdeibert
Posts: 8
Registered: ‎12-20-2005
Message 1 of 2 (2,108 Views)

Link Aggregation Problem: "The port is not configured properly" on HP V1910-48G Switch

[ Edited ]

Hello There,

 

the subject says it all: After a power failure the Link Aggregation of my HP V1910-48G Switch fails on two ports. When I remove the aggregation I can access both of the linked ports. If I enable them it's not working anymore. I updated to latest fw. Somehow I doubt there's a connection with the power failure, maybe more a formerly unsaved configuration ? In the Member port details I see:

GigabitEthernet1/0/46     Unselected     The port is not configured properly
GigabitEthernet1/0/48     Unselected     The port is not configured properly

 

What do I miss ? Help kindly appreciated.

 

Regards

Carsten

 

 

 

P.S. this thread has been moved from Switches, Hubs, Modems (Legacy ITRC forum) to Web and Unmanaged. - Hp Forum Moderator

Occasional Advisor
cdeibert
Posts: 8
Registered: ‎12-20-2005
Message 2 of 2 (2,085 Views)

Re: Link Aggregation Problem: "The port is not configured properly" on HP V1910-48G Switch

Just figured out that "The port is not configured properly" simply means "plug-in an ethernet cable". Actually it now seams that somehow these two ports are working when they are not in aggregation mode, but not when they are linked. Other links aggregations do work, as I figured out.

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.