HP IVM guest issue BOOT DISK (116 Views)
Reply
Valued Contributor
chindi
Posts: 362
Registered: ‎07-24-2008
Message 1 of 3 (116 Views)
Accepted Solution

HP IVM guest issue BOOT DISK

[ Edited ]

Hi ,

 

We have HP IVM envt in our setup.

Where base OS is hpux 11iv3  and guest OS is 11iv2 .

We ahev boot disk from SAN assigned to base OS we dont know why it is assigned.

So we just unpresented it from EMC VNX5500 , to our horror the guest OS stopeed responding for those 2 min, and when we presenetd it back to Base OS all was fine again.

 

What could be the connection of ths lun from BASE to GUEST O.S ??????

 

P.S. This thread has been moved from HP-UX>System Administration to HP-UX > virtualization. -HP Forum Moderator

Please use plain text.
Frequent Advisor
suvy12
Posts: 48
Registered: ‎11-16-2010
Message 2 of 3 (105 Views)

Re: HP IVM guest issue BOOT DISK

Check if this disk is assigned to Guest using

# hpvmstatus -v -p "guest"

 

or

 

hpvmdevmgmt -l check for the disk

 

 

Please use plain text.
Occasional Advisor
rkjha_hp
Posts: 7
Registered: ‎08-10-2011
Message 3 of 3 (66 Views)

Re: HP IVM guest issue BOOT DISK

check the status from hpvmstatus -v and find out if the said disk is assign to any guest.
Connection of luns from base to guest is, either you can assign the disk direct to guest using NPIV or you can use the luns from base machine as a lv partition or raw partition to assign the guest.

rgds
Please use plain text.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation