Creating VPAR for the first time (156 Views)
Reply
Super Advisor
Yaboto
Posts: 451
Registered: ‎02-07-2007
Message 1 of 4 (156 Views)

Creating VPAR for the first time

 

I freshly installed HP-UX DC OE. What are the steps involved in creating VPAR.

 

Please use plain text.
Acclaimed Contributor
Torsten.
Posts: 23,261
Registered: ‎10-02-2001
Message 2 of 4 (126 Views)

Re: Creating VPAR for the first time

It depends on the version you want to install (5.x or 6.x).

See

http://www.hp.com/go/hpux-vpar-docs

Hope this helps!
Regards
Torsten.

__________________________________________________

There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________

No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! star in the left column!   
Please use plain text.
Super Advisor
Yaboto
Posts: 451
Registered: ‎02-07-2007
Message 3 of 4 (116 Views)

Re: Creating VPAR for the first time

Please,

 

What is the difference between the physical server and the VSP?

Please use plain text.
Frequent Advisor
Primesh Abeysinghe
Posts: 39
Registered: ‎04-27-2010
Message 4 of 4 (98 Views)

Re: Creating VPAR for the first time

Hi,
VSP should be a physical server, In HP-UX and many more hypervisors.  Since we are talking about HP-Ux it should be Rx server or RP server or Itenium blade.

To create Vpar

#vparcreate –P <vparname>  -a memory:4G –a cpu:3

Like that

You can edit existing vpar using

#vparmodify

See the status

#vparstatus

Adding disk you you can straight away add disk path or if it is fiber or SCSI you can add the path of the card

To disk and network you have to add as “avio” devices.

Disks
#vparmodify –P <vparname> -m disk:avio_stor::disk:/dev/rdisk/disk20

Network

You may need to create vswitches

#vparnet –c –S vslan1 –n 1 (only the ppa number is used to indicate the lan)

Start & stop the switch:

#vparnet –b –S vslan1

#vparnet –h -S vslan1

To show vswitch status

#vparnet –S vslan1

Add port to vpar

# vparmodify -P <vparname> -a network:avio_lan::vswitch:vslan1:portid:2

 

 

reffer the attached doument you can download more in internet will give you more information

--

Best regards and good luck

Primesh

 

Please use plain text.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation