05-08-2014 12:00 PM - last edited on 05-09-2014 03:35 AM by RASHMI
I have an intergrity superdome server where i am running 5 vpars. I need your help to know what should be the Auto file entry in all those vpars.
i was just miorroring one of the vpars root disk and when i checked the AUTO file entry in it using below command,
efi_cp -d /dev/rdisk/disk5_p1 -u /EFI/HPUX/AUTO /tmp/auto
i found this,
# cat /tmp/auto
I am confused, if this is the correct entry, or it should be "boot vpmon -a" here.
My question is:-
1. I mean we need "boot vpmon -a" to boot mon, but is it only required in primary disk of first vpar and all others can have "boot vmunix" or not?
2. If all vpars must have "boot vpmon -a", then what about during all vpar boot. will they try to load the mon again and again, even it is already in place?
PS- This thread has been moved from LVM and VxVM to HP-UX > Virtualization - Forum Moderator
05-10-2014 06:00 PM
The first vPar would have the vpmon auto file. You have to decide whether everything starts at once (vpmon -a) or whether you need to watch each vPar to troubleshoot problems. vpmon is the vPar wrapper that enables vPars to function. The rest of the vPars would boot using vmunix. Only one vpmon can run.
However, you did say that you are mirroring drives. So the recommended boot string would be:
boot vmunix -lq
which will allow the vPar to boot with the loss of one disk (low quorum).
05-11-2014 11:46 PM
SuperDome2 or an earlier model?
from the OS.
Hope this helps!
There are only 10 types of people in the world -
those who understand binary, and those who don't.
No support by private messages. Please ask the forum!
If you feel this was helpful please click the KUDOS! thumb below!