Re: Adding iso to hpvm is seen as a block device (196 Views)
Reply
Advisor
paul_xedos
Posts: 33
Registered: ‎08-05-2009
Message 1 of 3 (203 Views)
Accepted Solution

Adding iso to hpvm is seen as a block device

Hi,

I'm running 11.31 on a host and have created a 11.31 hpvm

Attempting to boot from the iso fails and examination at EFI level shows that the iso is seen as a block device rather than an iso

 

host# swlist | grep -i integ
  BB068AA                       B.06.20        HP-UX vPars & Integrity VM v6
   SG-IVS-Toolkit                B.02.00        Serviceguard Toolkit for Integrity Virtual Servers
  T8718AC                       B.06.20        Integrity VM Online Migration Software

hpvmmodify -P hiptc801 -a disk:avio_stor::file:/iso/HPUX11iv3-Mar13.iso

 

# hpvmstatus -P hiptc801
[Virtual Machine Details]
Virtual Machine Name VM #  Type OS Type State
==================== ===== ==== ======= ========
hiptc801                 1 SH   UNKNOWN On (EFI)  

[Runnable Status Details]
Runnable status         : Runnable


[Storage Interface Details]
vPar/VM                                Physical
Device  Adapter    Bus Dev Ftn Tgt Lun Storage   Device
======= ========== === === === === === ========= =========================
disk    avio_stor    0   0   0   0   0 disk      /dev/rdisk/disk8
disk    avio_stor    0   0   0   1   0 file      /iso/HPUX11iv3-Mar13.iso

[Network Interface Details]
Interface Adaptor    Name/Num              PortNum Bus Dev Ftn Mac Address
========= ========== ===================== ======= === === === =================
vswitch   avio_lan   vmswitch              1         0   1   0 0e-e3-0a-90-02-ee

[Direct I/O Interface Details]
vPar/VM                                       Physical
Device  Adapter Bus Dev Ftn Mac Address       Storage   Device
======= ======= === === === ================= ========= ===========

I have tried with several iso ( which have worked on other machines) and all produce the same results

 

On hpvm guest console

Device mapping table
  blk0 : Acpi(PNP0A03,0)/Pci(0|0)/Scsi(Pun0,Lun0)
  blk1 : Acpi(PNP0A03,0)/Pci(0|0)/Scsi(Pun1,Lun0)
Shell>

 

Thanks

Pau

 

Please use plain text.
Respected Contributor
Stan_M
Posts: 92
Registered: ‎09-12-2011
Message 2 of 3 (198 Views)

Re: Adding iso to hpvm is seen as a block device

It should be :

dvd:avio_stor::file:/iso/...

and not

disk:avio_stor::file:/iso/...

 

Also make sure you have the correct ISO image (March 2013 consists of 2 DVDs).

 

HTH

Stan

Please use plain text.
Advisor
paul_xedos
Posts: 33
Registered: ‎08-05-2009
Message 3 of 3 (196 Views)

Re: Adding iso to hpvm is seen as a block device

Hi Stan,

 

What a fool I've been!

 

That was the fix

 

Thanks very much

Paul

Please use plain text.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation