Re: How to return call to auto attendant after press wrong extension (282 Views)
Reply
Occasional Contributor
worawit
Posts: 9
Registered: ‎11-01-2011
Message 1 of 4 (294 Views)
Accepted Solution

How to return call to auto attendant after press wrong extension

VCX 9.5

 

How to return call to auto attendant after press wrong extension?

 

Current:

After clients press extension number[wrong number] AA forward call to IPT and terminate call.

 

Valued Contributor
John_Katzmaier
Posts: 72
Registered: ‎08-23-2010
Message 2 of 4 (286 Views)

Re: How to return call to auto attendant after press wrong extension

Hi,

 

If you use the option Bridge Transfer instead of Transfer to Phone, then if the caller dials an invalid extension, it should return the call to the Auto Attendant.

 

You may need to increase the number of minutes on the Virtual Calling Card for the Auto Attendant mailbox, since using Bridge Transfer uses the minutes from the Virtual Calling Card. It is also recommended to change the number of digits on the Virtual Calling Card (Outdial Options in the web interface) to the number of digits in your extension numbers.

Occasional Contributor
worawit
Posts: 9
Registered: ‎11-01-2011
Message 3 of 4 (282 Views)

Re: How to return call to auto attendant after press wrong extension

Thank you. it fine work.

Occasional Visitor
Salvador_Suro
Posts: 1
Registered: ‎07-24-2012
Message 4 of 4 (249 Views)

Re: How to return call to auto attendant after press wrong extension

Hello, I need to set up an auto attendant on a VCX MSR 30-40, with the following software version: 9.8.15 VCX Connect.

What is the procedure to configure? Or a manual where I can guide?

Thanks and regards

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.