Unable to evaluate the expression. The debugger evaluation timeout was exceeded | QTP 11.0 (295 Views)
Reply
Occasional Visitor
ELearer
Posts: 1
Registered: ‎01-15-2014
Message 1 of 1 (295 Views)

Unable to evaluate the expression. The debugger evaluation timeout was exceeded | QTP 11.0

[ Edited ]

I am getting the following below error message. 

 

Unable to evaluate the expression. The debugger evaluation timeout was exceeded

 It corrupted my Debug Viewer.

 

Found the below in the an old thread from this forum but both workaround didn't work out for me for the following reasons

A. There is nothing in my watch list

B. Unable to find MicDebugView in the MicTest folder

 
When you use debug commands (e.g. "Step Over", "Step Into"), the evaluation of expressions in the Watch or Variables tabs of the Debug Viewer might exceed internal evaluation limits. In this case, the following message is displayed in the Debug Viewer: "Unable to evaluate the expression. The debugger evaluation timeout was exceeded."

Workaround A: Try to remove some expressions from the Watch list or simplify complex expressions and proceed with debugging.

Workaround B: Try to increase the evaluation timeout by adding the 'DbgEvalTime' registry key value. For example:

[HKEY_CURRENT_USER\Software\Mercury Interactive\QuickTest Professional\MicTest\MicDebugView] "DbgEvalTime"=dword:0000000F

 

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.