12-19-2013 01:10 AM
I am using UFT 11.52 in win7 64 bit machine. I am unable to perform continuou execution with UFT. Its getting crashed in the middle without showing any errors. Please advice me. Its happing all the time I am unable to procedd with execution.
12-19-2013 01:38 PM - edited 12-19-2013 01:43 PM
I did run into similar issues especially while trying to access the debugger and as just upgraded to 11.53 I see it being more stable. As I'm more leaned toward suggesting you to do the same, can you please specify more details to see if we can narrow down the problem/issue
1. are you running UFT in run mode or debug mode
2. are you running the test/bpt from QC/ALM or directly from UFT ( I had crashing issues mostly while running test from ALM/QC in debug mode)
And am using UFT v11.53 on both Win 7 32 and 64-bit OS
Hope this helps.
-- Opinions expressed in my postings are mine alone, and do not reflect the opinions of my employer. No warranties express or implied for any solution/suggestion posted.
12-23-2013 08:45 PM
I am running UFT in run mode.
Also I tried to install UFT 11.53 patch. Its not getting installed. Its showing copying files for long time. Dunno what the problem is.
Please help me in resolving the issue.
12-27-2013 02:34 AM
Unsufficient permissions might be the problem.
Any installation change of UFT (including un/installation or repair of the product as well as any of its patches/SPs) must be done with full admin right on the machine as well as UAC & DEP disbabled, and you should have at least following permissions for standard use of UFT: http://support.openview.hp.com/selfsolve/document/
I would suggest you perform clean reinstall of UFT with full admin rights as well as UAC & DEP disbaled (as suggested above), in order to make sure everything with the installation is ok: http://support.openview.hp.com/selfsolve/document/
If you find that this or any post resolves your issue, please be sure to mark it as an accepted solution.”