Re: UFT 11.51 Pass parameters from File level to Action level (1440 Views)
Reply
Advisor
Posts: 39
Registered: ‎09-22-2011
Message 1 of 4 (1,464 Views)
Accepted Solution

UFT 11.51 Pass parameters from File level to Action level

Hi,

Know this seems elementary, but since moving to UFT recently looked at it today & as the GUI is different, could not figure out how to connect the parameters defined at Test level to the ones defined at Action level.

Any help apprecited.

Thx.

Quality - a way of life!
Highlighted
Frequent Advisor
Posts: 57
Registered: ‎04-11-2013
Message 2 of 4 (1,440 Views)

Re: UFT 11.51 Pass parameters from File level to Action level

Menu Bar -> View -> Test Flow will have the actions of the entire test.

 

Right click on Action and selecting Action properties has a tab for parameters(specific to actions)

 

Menu Bar -> File -> Settings has Parameters option defined at test level.

 

+pavan

Advisor
Posts: 39
Registered: ‎09-22-2011
Message 3 of 4 (1,434 Views)

Re: UFT 11.51 Pass parameters from File level to Action level

Thx Pavan!

For some reason it didn't seem intuitive...been used to using only the flow on the left side...now getting to use the center pane...may take a bit of getting used to...:)

Rgds.

Quality - a way of life!
Super Advisor
Posts: 216
Registered: ‎02-08-2013
Message 4 of 4 (1,387 Views)

Re: UFT 11.51 Pass parameters from File level to Action level

I find the new view ok for actions that are "left behind" i.e actions that really I had there without usinf or without them being called from another action.

 

Good for clean up.

 

:)

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.