Re: UFT 11.5 not spying the objects properly on IE (538 Views)
Reply
Occasional Visitor
astephen
Posts: 1
Registered: ‎01-07-2014
Message 1 of 4 (625 Views)

UFT 11.5 not spying the objects properly on IE

After upgrading QTP to UFT 11.5, the object spy is identifying objects off the line. For eg: when try to spy on a text box, if I point the spy on the text box it doesn't identify it. I have to point it out of the text box towards the right. This was perfectly fine before the upgrade.

HP Expert
Ana_Noncheva
Posts: 245
Registered: ‎08-06-2013
Message 2 of 4 (600 Views)

Re: UFT 11.5 not spying the objects properly on IE

Hello,

 

From screenshot it can be seen that your browser's zoom level is set to 95%.

Could you please set it to 100% and check again the problem?

 

Regards,

Ana

 

“HP Support
If you find that this or any post resolves your issue, please be sure to mark it as an accepted solution.”
Occasional Visitor
richnixon69
Posts: 1
Registered: ‎01-11-2014
Message 3 of 4 (583 Views)

Re: UFT 11.5 not spying the objects properly on IE

object spy does not work 

Senior Member
Clifford Johnson
Posts: 3
Registered: ‎03-27-2008
Message 4 of 4 (538 Views)

Re: UFT 11.5 not spying the objects properly on IE

I was having a similar problem. I found a fix. IE has a Zoom level. Right Click on the GEAR (top-right corner), click on/check/enable Status Bar.  Now @ the bottom-right corner of the browser window you will see the Zoom level. Change it to 100%. It worked for me.

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.