QTP not recognising SAPList object (330 Views)
Occasional Visitor
Posts: 1
Registered: ‎03-27-2014
Message 1 of 3 (330 Views)

QTP not recognising SAPList object

[ Edited ]



I am trying to automate a webdynpro application where I am trying to select a value from a dropdown list. OR recognises this as an SAPList object. But when I playback the script it fails to recognise the object. I tried giving the micclass also but it will not recognise it. The code so far-


Browser("SAP NetWeaver Portal").Page("SAP NetWeaver Portal").Frame("iframe_Roundtrip_133661597").SAPList("Did the accident occur").Click


Any input would be appreciated.





P.S. This thread has been moved from Community Feedback & Suggestions to  Unified Functional Testing (formerly QTP) News and Support Forum. -HP Forum Moderator

HP Expert
Posts: 168
Registered: ‎04-13-2012
Message 2 of 3 (302 Views)

Re: QTP not recognising SAPList object

What is the exact error message displayed? Does it talk about the SAPList or its parent object?

I suggest to compare the properties in the Object Repository for that specific object against the properties of the object when it failed... You might find differences, hence the root cause.

"HP Support
If you find that this or any post resolves your issue, please be sure to mark it as an accepted solution."
Posts: 26
Registered: ‎11-02-2012
Message 3 of 3 (286 Views)

Re: QTP not recognising SAPList object



I had the same problem sometime ago. There is a problem with this kind of object. At the end I wrote a shell script to select the item on the list. 


Hope this helps!



The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.