Re: HP FC HBA Error RxPower(mW) fault (174 Views)
Reply
Occasional Contributor
Posts: 5
Registered: ‎04-05-2013
Message 1 of 2 (201 Views)

HP FC HBA Error RxPower(mW) fault

[ Edited ]

Hi Frds,

 

I need Conformation & solution.

 

Connectivitive Structure:

Tape Library Directly connected to FC HBA Card.

 

In this evnening I got a error msg from SAN Surffer Error is ("RxPower Fault mW"), i tried web support it says FC HBA issue.

All the three LED's Blinking on the FC HBA card(RED, Green, Orsnge)

but when i connect the same FC HBA card in san switch then no error msg on the SAN Surfer.

 

is there problem is FC card or Tape Library?????

 

Hardware Details:

 

Library : MSL2024 G3 series

FC HBA:  AK344A:HP 81Q 8Gb 1-port PCIe Fibre Channel Host Bus Adapter

 

Thanks & Regards,

Ramachandran U.

 

 

 

This thread has been moved from Tape Backup (Small and Medium Business) to Tape Libraries and Drives

Honored Contributor
Posts: 3,871
Registered: ‎06-14-2009
Message 2 of 2 (174 Views)

Re: HP FC HBA Error RxPower(mW) fault

Hi,

sounds like the problem is in the FC Library if the card is working when connected to the SAN-switch.

If you have another FC card available you could try connecting the library to that.

Make sure the port on the FC HBA and library is set to direct connect.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.