01-22-2013 05:38 AM - last edited on 01-22-2013 11:26 PM by Cathy_xu
We've just purchased a refurbished DL360 G6 along with a HP Storageworks Ultrium 1760 SAS lto4.
I installed Server 2003 through Smart Start. When I log on and navigate to the Array Config Utility I can see the p410i and p411 RAID controllers.
When I attach the tape to drive to either port of the p411 controller nothing appears in device manager.
We have another DL360 G6 which has the same RAID controller installed, but has a Ultrium 920SAS lto3 attached.
When I attach the 920SAS drive to our new server, the drive is detected. Using the old sas cable with the new server and tape drive, no drive is detected. If I attach the new tape drive to the old server with either cable, the device is detected.
Any advice as to what the issue is would be appreciated. Could it be a dodgy RAID card, although our other tape drive works fine with the server??
P.S.This thread has been moved from Tape Backup (Small and Medium Business) to Tape Libraries and Drives- HP Forums Moderator
Solved! Go to Solution.
01-22-2013 05:43 AM
Same connector port used?
Hope this helps!
There are only 10 types of people in the world -
those who understand binary, and those who don't.
No support by private messages. Please ask the forum!
If you feel this was helpful please click the KUDOS! thumb below!