INTEGRATION HP OM and NNM (1174 Views)
Reply
Frequent Advisor
Marat Zalotdinov
Posts: 61
Registered: ‎04-07-2011
Message 1 of 2 (1,174 Views)
Accepted Solution

INTEGRATION HP OM and NNM

Hello.

How to integrate HP OM 9.x and NNM?
There is a manual?

Trusted Contributor
hp4u
Posts: 571
Registered: ‎09-16-2010
Message 2 of 2 (1,152 Views)

Re: INTEGRATION HP OM and NNM

There are two ways 1)through web service and 2)agent based

In my case I am using agent based integration between NNM and HPOM.

Please follow the below steps:

The implementation steps for "" Agent based integration ""
Refer: http://support.openview.hp.com/selfsolve/document/KM1097954/binary/nnmi_deployment_9.10.pdf page 526+

1-Add the NNMi node to the OMW.
2-Install OMW Agent on the NNMi machine
3-Create SNMP Node for each network device or Create an external node with <*>.<*>.<*>.<*> IP address
4-Create the SNMP trap policy file by entering the following command:
nnmopcexport.ovpl -u -p -template "NNMi Management Events" -application "NNMi" -file NNMi_policy.dat
refer: http://support.openview.hp.com/selfsolve/document/KM1097957/binary/nnmi_referencepgs_9.10.pdf page 129
5-Import the policy file to OMW by using ImportPolicies command like ImportPolicies /t NNMi_policy.dat
6- Deploy the policy to NNMi
7-On the NNMi management server, configure the HP Operations agent with a
custom port for receiving SNMP traps from NNMi
ovconfchg -ns eaagt -set SNMP_TRAP_PORT 5162 -set SNMP_SESSION_MODE NNM_LIBS
Restart the agent:
ovc -restart opctrapi

Enable Integration on NNMi
Click Integration Module Configuration > HPOM >HPOM agent implementation
Continue with the steps as per the Deployment Guide Page 530

 

I will  suggest refer HP Document to do it.

Regards,
hp4u
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.