Assigning or creating same node in different layouts in OMU 9.0 (128 Views)
Reply
Frequent Advisor
Posts: 53
Registered: ‎10-30-2013
Message 1 of 2 (128 Views)

Assigning or creating same node in different layouts in OMU 9.0

Hi All, 

 

I'm creating a Node Hierarchy in OMU. I have a created a node X which is present in the layout Y. Is it possible to assign the node X to layout Z without removing it from Y?  

 

------------Layout Y

|   |--------Node X

|

------------Layout Z

|    |--------Node X

 

Or is there a way to create a new node with same attributes as node X?

 

Thank You 

 

HP Expert
Posts: 124
Registered: ‎08-31-2006
Message 2 of 2 (113 Views)

Re: Assigning or creating same node in different layouts in OMU 9.0

Hello,

 

I'm afraid this is not possible within the product and even worse, has been requested before and R&D has determined not to implement this change request:

 

http://support.openview.hp.com/selfsolve/document/LID/QCCR1A170815

 

Best regards,

Christian

If you find this or any post resolves your issue, please make sure to mark it as an accepted solution
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.