System Abort 725 (227 Views)
Reply
Occasional Visitor
Edp_3
Posts: 1
Registered: ‎07-11-2008
Message 1 of 3 (227 Views)

System Abort 725

During boot:
System abort 725 from subsystem 122
secondary status info = -55
subsys= 107
system halt 7,$02D5

What is the cause of this?
Respected Contributor
Stan Sieler
Posts: 321
Registered: ‎10-16-1996
Message 2 of 3 (227 Views)

Re: System Abort 725

725 =
'The port's server caused an unexpected escape.'

Secondary status =
'A DATA MEMORY PROTECTION trap was detected because of an invalid target address
alignment.'

Beyond that, we'd need to see a memory dump.

Stan
sieler@allegro.com
Honored Contributor
Kwan Fong, Emile
Posts: 1,162
Registered: ‎07-10-2000
Message 3 of 3 (227 Views)

Re: System Abort 725

Hello EDP,

Is your system running MPE/iX OS release 6.0? If so, does the SA725 occur right after system bootup? If so, there are many instances where the spooler subsystem has started all printer spoolers devices including network printers _ Before _ the network transport and service is started. if there are spoolfiles ready to print to your network printers before network is started, SA725 may occur.

You may want to install the latest 6.0 network patch NSTGDK3 to fix this issue or as a workaround until you install the patch, you ensure to start the network services before the printjobs print.

The problem is fixed on OS releases 6.5, 7.0 and 7.5.
King is the customer!
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.