Re: Integrity BL860c I2 monitoring P410i (263 Views)
Reply
Occasional Advisor
witchy
Posts: 13
Registered: ‎08-07-2012
Message 1 of 2 (382 Views)

Integrity BL860c I2 monitoring P410i

Folks,

 

I'm building the above box with an embedded P410i talking to a D2200sb storage blade. Array controller is in RAID mode.

 

All is working nicely, System Management Homepage, WBEM, SNMP etc. However, when I simulate a drive failure in the D2200sb by pulling a drive the controller will correctly start rebuilding on the hot spare, MSA$UTIL shows the rebuild and that a drive's been pulled..... but nothing tells the management utilities and VMS doesn't log any errors. When the rebuild completes I replace the pulled drive and the controller rebuilds onto that, returning the hot spare.

 

Anyone know what actually logs these errors?

 

Cheers

 

Adrian

Please use plain text.
Trusted Contributor
Peter Zeiszler
Posts: 354
Registered: ‎12-23-2003
Message 2 of 2 (263 Views)

Re: Integrity BL860c I2 monitoring P410i

Do you have WEBES or SMH installed?

 

Check both of these and see if it is there or in the errlog file.

Please use plain text.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation