HP3000 and a connection to open view (210 Views)
Occasional Contributor
Posts: 4
Registered: ‎01-27-2010
Message 1 of 1 (210 Views)

HP3000 and a connection to open view

Yesterday I started getting calls from 1 of my users that there was an issue with there dumb terminal – it was ‘sluggish’ (we really only have 3 units connected (somehow) to this DTC – two dumb terminals and one printer(my main system printer) – all connected to a rs232 port - I changed the keyboard, then the monitor, rebooted the overview pc, reset the dtc04 and dtc03 from the screen – still nothing, went to the other dumb terminal and saw the same results. Today I was listening to a job print and it would print 10 lines and pause, print some more, pause, over and over – sluggish just like the terminals

What is the problem – I have NO IDEA as to what it may be and unfortunately this weekend is my phy inv and I need a ‘good fast printer’ not a on again off again
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.