Re: mkisofs 11iv3 (388 Views)
Frequent Advisor
Posts: 72
Registered: ‎04-02-2009
Message 1 of 5 (388 Views)
Accepted Solution

mkisofs 11iv3

Hello ,

I need to do an iso image on HP-UX? In the previous version of HP-UX 11iv1 et 11iV2 a command mkisofs existed. It came from the package HP-UX dvd+rw-tools. It seems this package is not available for 11iV3 . Do you know if HP-UX provide another command to do that? or perhaps another package ?
Thank you for you replies .
Regards ,
Trusted Contributor
Posts: 139
Registered: ‎02-13-2008
Message 2 of 5 (388 Views)

Re: mkisofs 11iv3

HI Merieux,

Create HP-UX 11i v3 bootable CD/DVD media for two-step media recovery
On a system with a CD/DVD writer and the same version of Ignite-UX as on your tape, execute the following command (iso_directory is the target directory for the .iso media file and the -r option specifies the release, such as B.11.23 or B.11.31):

#make_media_install -r B.11.31 -m iso_directory

Have a look at the link below.

And dont forget to give the points.

Exalted Contributor
Posts: 33,806
Registered: ‎08-15-2002
Message 3 of 5 (388 Views)

Re: mkisofs 11iv3


This doc would seem to indicate its part of Ignite which is available at

Steven E Protter
Owner of ISN Corporation
Frequent Advisor
Posts: 72
Registered: ‎04-02-2009
Message 4 of 5 (388 Views)

Re: mkisofs 11iv3

thank your for your reply
Honored Contributor
Posts: 9,164
Registered: ‎02-23-2005
Message 5 of 5 (388 Views)

Re: mkisofs 11iv3

If you actually want mkisofs, it's part of
the cdrtools package. I normally look in

and fetch the latest source kit. Older,
released versions are not far away.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.