VA7100 configuration issue (112 Views)
Reply
Valued Contributor
Posts: 342
Registered: ‎12-06-2002
Message 1 of 2 (112 Views)

VA7100 configuration issue

Hi Everyone,

 

I have a VA7100 that is connected to a rp5470 running HP-UX 11.11

 

The VA7100 has two controllers on it and one of them was bad. I replaced the controller and now I cannot see any of the controllers using cvui. I am not reall good at using armdsp so i am not sure, but it seems that i cannot see any of the controllers that i was seeing before i replaced the bad controller.

 

I am not worried about saving the data on this VA7100 so i can start from scratch but not sure how to do that. Do I need to hook up a serial monitor to the controller port and use the vfp to start over?

 

Also, both controllers have a yellow light on the controller indicator.

 

Any help would be greatly appreciated!

 

Thanks

Tim

Valued Contributor
Posts: 342
Registered: ‎12-06-2002
Message 2 of 2 (109 Views)

Re: VA7100 configuration issue

just an update,

 

I am not at the site that his VA7100 is at so i was trying to do it remotely and had a sysadmin replace the controller. He just informed me that the new controller also has a yellow light next to both of the DIMM's indicator. Not sure how this would affect both controllers but.....

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.