Re: SNMP error when bonding set to active/backup (186 Views)
Reply
Occasional Visitor
dovi5988
Posts: 2
Registered: ‎12-30-2013
Message 1 of 3 (219 Views)

SNMP error when bonding set to active/backup

[ Edited ]

Hi,

 

I have set up in linux mode=1 (active/backup). When doing an SNMP check I get back:

Compaq/HP Agent Check: status of the NIC logical group (standbyFailed)

 

Why is that if both interfaces are up?

 

[root@serv1 ~]# ethtool bond0 | grep Link
        Link detected: yes
[root@serv1 ~]# ethtool eth0 | grep Link
        Link detected: yes
[root@serv1 ~]# ethtool eth1 | grep Link
        Link detected: yes
[root@serv1 ~]#

 

 

P.S. This thread has been moved from Laserjet to Linux > sysadmin. - Hp Forum Moderator

Please use plain text.
Occasional Visitor
dovi5988
Posts: 2
Registered: ‎12-30-2013
Message 2 of 3 (189 Views)

Re: SNMP error when bonding set to active/backup

Since no one is repsonding here does anyone know how to contact HP to get an answer?

Please use plain text.
Acclaimed Contributor
Dennis Handly
Posts: 24,958
Registered: ‎03-06-2006
Message 3 of 3 (186 Views)

Re: SNMP error when bonding set to active/backup

>does anyone know how to contact HP to get an answer?

 

If you have a support contract try contacting the HPSC:
http://www.hp.com/go/hpsc

Please use plain text.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation