How to configure new LUNs from EVA (1521 Views)
Reply
Occasional Contributor
aremint
Posts: 8
Registered: ‎07-26-2011
Message 1 of 5 (1,521 Views)

How to configure new LUNs from EVA

Hi,

 

May I know how to create new LUNs from EVA. For your information this is my first time configure LUNs.

The only information that i found is:

 

cvui - creates luns

    Choose storage array
    Create LUN
        Find last LUN
        Create with new lun number
    View existing luns

 

Hope someone can help me on this.

Appreciate your time and help.

Occasional Contributor
aremint
Posts: 8
Registered: ‎07-26-2011
Message 2 of 5 (1,500 Views)

Re: How to configure new LUNs from EVA

Hope someone can tell me where should I start to configure the new LUNs.

Honored Contributor
Robert_Jewell
Posts: 1,239
Registered: ‎06-26-2001
Message 3 of 5 (1,494 Views)

Re: How to configure new LUNs from EVA

Your question is very basic, as there is more to creating LUN's than just doing it.   THere are many items you need to consider regarding disk groups, vDisks and all of the associated properties and data protection levels.

 

How its done is through Command View.  So, if you dont know what Command View is or how to access it, then perhaps you need to ask yourself if you are the right person doing this job.  At any rate, here is a link to documentation for Command View:

 

http://h20000.www2.hp.com/bizsupport/TechSupport/DocumentIndex.jsp?contentType=SupportManual&lang=en...

 

Locate the Users Guide towards the bottom of that page.  Information regarding vDisk creation and LUN presentation is contained within this document.  Good luck!

 

-Bob

Acclaimed Contributor
Torsten.
Posts: 23,450
Registered: ‎10-02-2001
Message 4 of 5 (1,492 Views)

Re: How to configure new LUNs from EVA

>> cvui - creates luns

 

 

Yes, for command view SDM used for VA arrays

 

For EVA you have command view eva

 

 

Please clarify if you have an EVA or VA!


Hope this helps!
Regards
Torsten.

__________________________________________________

There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________

No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Occasional Advisor
Vijaya Ragavan_1
Posts: 11
Registered: ‎11-22-2009
Message 5 of 5 (1,429 Views)

Re: How to configure new LUNs from EVA

hi aremint

                     First Create a new vdisk form hp command view EVA and present to your host.After login into your host and give autopath discover ON --->insf -e ----> ioscan -fnC disk ----> autopath display you can get new lun with disk details.

 

Thanks & Regards

S.J.Vijaya Ragavan

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.