HP 9000 K370 Unknown Error Message (320 Views)
Reply
Frequent Advisor
glennes
Posts: 62
Registered: ‎04-20-2014
Message 1 of 4 (320 Views)
Accepted Solution

HP 9000 K370 Unknown Error Message

[ Edited ]

I have installed some networking (and other) software on my K370 and am now getting the following message after successful bootup (system at the # prompt):

 

INIT: Command is respawning too rapidly.

Will try again in 5 minutes.

Check for possible errors.

id: ded "/sbin/ded"

 

This error repeats itself every five minutes and the system does not return me to the # prompt. How do I exit this loop?

 

Any idea which program is causing this error to appear? What is the fix for it? How do I isolate the particular program causing this so I can remove it or fix it?

 

On the bootup checking run, I get:

 

Starting Datakit subsystem - fail       (all other checks pass without error)

 

and

 

lvol5 and lvol8 need checking

 

Is the Datakit subsystem error/fail causing this? How do I check lvol5 (opt) and lvol8 (var)?

 

Thanks!

Glenn

 

 

P.S. This thread has been moved from HP 9000 to HP-UX > sysadmin. - Hp Forum Moderator

Honored Contributor
Patrick Wallek
Posts: 13,787
Registered: ‎06-21-2000
Message 2 of 4 (298 Views)

Re: HP 9000 K370 Unknown Error Message

Boot up into single-user mode, mount /usr and /var and edit the /etc/inittab file.   I would comment out the line that appears to be causing problems, which appears to be the line that starts with 'ded'.

 

If the syntax of that line in inittab is incorrect then it can cause you problems.

Honored Contributor
Patrick Wallek
Posts: 13,787
Registered: ‎06-21-2000
Message 3 of 4 (297 Views)

Re: HP 9000 K370 Unknown Error Message

As to checking lvol5 and lvol8, I assume the system is saying to check them with 'fsck'.

 

To do that:

 

# fsck -y -o full /dev/vg00/rlvol5

# fsck -y -o full /dev/vg00/rlvol8

Frequent Advisor
glennes
Posts: 62
Registered: ‎04-20-2014
Message 4 of 4 (286 Views)

Re: HP 9000 K370 Unknown Error Message

Patrick...

 

Commenting out the 'ded' line in inittab fixed the problem.

 

Also running fsck on the two lvol's fixed them, as well.

 

Thanks for the great help!

Glenn

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.