Set Date and time in HP Procurve Switch (50762 Views)
Reply
Occasional Visitor
Posts: 1
Registered: ‎11-03-2009
Message 1 of 4 (50,762 Views)

Set Date and time in HP Procurve Switch

How to set date and time HP Procure 2810 Switch.
I have managed to set the time but not the date.

What CLI command should I type?
Respected Contributor
Posts: 181
Registered: ‎07-21-2008
Message 2 of 4 (50,762 Views)

Re: Set Date and time in HP Procurve Switch

Hi,

sw1-test-lab-35c(config)# time
begin-date The begin date of daylight savings time
MM/DD[/[YY]YY] New date <----------
daylight-time-rule The daylight savings time rule for your location
end-date The end date of daylight savings time
HH:MM[:SS] New time <----------
timezone The number of minutes your location is West(-) or
East(+) of GMT

sw1-test-lab-35c(config)# time
Valued Contributor
Posts: 76
Registered: ‎09-29-2009
Message 3 of 4 (50,762 Views)

Re: Set Date and time in HP Procurve Switch

Als makes sense to configure (s)ntp

"SNTP Server 1.1.1.1"
Respected Contributor
Posts: 353
Registered: ‎10-20-2009
Message 4 of 4 (50,762 Views)

Re: Set Date and time in HP Procurve Switch

use the command as this.
#time month/day/year hr:min:sec
#time timezone
#time daylight-time-rule
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.