Failover switch config / 1810G-24 (236 Views)
Reply
Frequent Advisor
MGaccess
Posts: 40
Registered: ‎09-20-2004
Message 1 of 1 (236 Views)

Failover switch config / 1810G-24

Hi, all of my ESX servers and iSCSI storage devices have primary and standby NIC's so I would like to configure Two switches the same way. Switch01 would contain the primary NIC's and Switch02 would contain the standby NIC's.

1) If I were to configure two 1810G-24 switches with 2 VLAN's as shown in the attached graphic.
2) Then connect Switch01 to Switch02 via port 23 *tagged*

Would connecting Switch01 to Switch02 via port 23 enable the two switches to communicate and allow the traffic to pass? Would that config be sufficient if Switch01 were to fail?

By the way, Port 1 is the ISP drop and it only needs to communicate with the ESX server ports on VLAN 1 as defined in the graphic.

Any feedback is surely appreciated! Thoughts?
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.