CLI in 3Com Baseline Switch 2952-SFP (8673 Views)
Reply
Occasional Contributor
Iroal
Posts: 2
Registered: ‎07-27-2011
Message 1 of 3 (8,673 Views)

CLI in 3Com Baseline Switch 2952-SFP

Hi,

 

I've just installed a new 3Com Baseline Switch 2952-SFP and I don't know how to access to all functionality via TELNET, I access with management access level.

 

I've just access only to this commands:

 

 initialize 
 ipsetup    
 password   
 ping       
 quit       
 reboot     
 summary    
 upgrade    

 

How can I access to all the commands?

 

I want to create a Vlan using IP subnet and I cannot do it using Web interface.

 

Thanks.

 

Regards

 

 

Please use plain text.
Advisor
mbrownnyc
Posts: 27
Registered: ‎09-26-2008
Message 2 of 3 (8,423 Views)

Re: CLI in 3Com Baseline Switch 2952-SFP

[ Edited ]

at 3COM CLI

_cmdline-mode on

[password is] 512900

sys [to elevate to configuration prompt]

 

I started manually enumerating the command tree.  See attached.

Please use plain text.
Advisor
mbrownnyc
Posts: 27
Registered: ‎09-26-2008
Message 3 of 3 (8,412 Views)

Re: CLI in 3Com Baseline Switch 2952-SFP

[ Edited ]

Wow.  I think I just found a goldmine:

 

I'm very giddy right now: 

 

The H3C S5500-52C-PWR-EI looks quite familiar, ey?

 

http://www.h3c.com/portal/Technical_Support___Documents/Technical_Documents/Switches/H3C_S5500_Serie...

 

[edit]

looks like I could be a little off with the model number, -EI switches support IPv6, and -SI switches don't.  This seems to be the difference.

Please use plain text.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation