hp2000 G3 new raid 6 setup (186 Views)
Reply
Occasional Contributor
t21drl
Posts: 2
Registered: ‎12-06-2013
Message 1 of 2 (186 Views)

hp2000 G3 new raid 6 setup

Recently started a new raid configuration to raid 6 from 5 and now i cannot see the raid via disk management on our server. on the SAN all lights are green. Looking at device manager i also cannot see that the SAN in connected even though the cables have not been moved from when it was working before.  Any ideas what i should be checked,i assume something on the SAN but cant think what.

Acclaimed Contributor
Torsten.
Posts: 23,450
Registered: ‎10-02-2001
Message 2 of 2 (178 Views)

Re: hp2000 G3 new raid 6 setup

If you create a new vdisk with new volumes, you need to map them again to the servers, Did you do this?

Hope this helps!
Regards
Torsten.

__________________________________________________

There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________

No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.