Upgrading an MSA 2000 G1 to P2000 G3 (700 Views)
Reply
eci
Visitor
eci
Posts: 1
Registered: ‎06-30-2011
Message 1 of 1 (700 Views)

Upgrading an MSA 2000 G1 to P2000 G3

Per:

http://h20195.www2.hp.com/v2/GetPDF.aspx/4AA0-8284ENW.pdf

it says:

When using heterogeneous expansion enclosures (6G and 3G) 
the MSA2000 (3G) expansion enclosures must be installed as the 
last enclosures and straight-through cabling must be deployed.

 

Can you elaborate on "must"? I would like to upgrade my existing 
MSA2000 G1, 4 enclosure setup. I am installing two new P2000 G3 
FC/iSCSI controllers in my existing MSA2000 G1 SAS 3G enclosure, 
as supported. I have to do this to upgrade the array and 
preserve data. I am adding 4 new P2000 6G enclosures. The 
devices will be installed top down like this:

1: P2000 G3 array head in MSA2000 Enclosure
2: P2000 6G enclosure
3: P2000 6G enclosure
4: P2000 6G enclosure
5: P2000 6G enclosure
6: MSA2000 3G enclosure
7: MSA2000 3G enclosure
8: MSA2000 3G enclorure

I do not want to use straight through cabling, I want to use 
fault tolerant. I understand that the B end of the array ahead 
will hit the 3G device first, while the A end will hit the 6G 
device first. I am willing to live with this. My question is on 
HP's use of the word "must" in the above quote sentence from the 
guide. Is there a reason other than slower performance why I 
can't use fault tolerant cabling here? Is there a critical 
reason? I have another functioning system using fault tolerant 
cabling in the same config without issue. If it is just " the B end will run at 3G" then I am fine with that. I can make my existing 3G vdisks owned by B, and new 6G vdisks owned by A. B can provide failover for A, at reduced speeds until is back up.

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.