Re: Priorities in EVA CA DR groups (225 Views)
Reply
Frequent Advisor
Posts: 32
Registered: ‎01-27-2009
Message 1 of 2 (225 Views)
Accepted Solution

Priorities in EVA CA DR groups

Hello,

I was wondering if it was possible to change the priority in any way with HP EVA and Continuous Access.

We have two EVA4400 which replicate to eachother by using MPX modules. (Asynchrone replication)

Last time one of our MPX modules crashed and caused the logspace to fill up. Afterwards a full copy was required. The full copy replication take approximately 2 days. Is it possible to give our SAP databases an higher priority than for example acceptation environment. This data is more critical than all other data.

Thanks in advance,

Ruben
Honored Contributor
Posts: 2,397
Registered: ‎11-09-2007
Message 2 of 2 (225 Views)

Re: Priorities in EVA CA DR groups

Not automatically, but you can configure the DR groups to suspend on link down and then all will be suspended when link is restored. Then you can chose which ones to enable, letting them sycrhonize or do a full copy.

The EVA4400 with updated firmware performs a fast full copy, does not copy the full vdisks, only the parts that have been modified since the last syncronization.

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.