Re: HP P2000 G3 SNMP Alerts (385 Views)
Reply
Occasional Visitor
adamb86
Posts: 2
Registered: ‎01-15-2014
Message 1 of 2 (387 Views)

HP P2000 G3 SNMP Alerts

Hey all new to the HP world.

 

We have a HP P2000 G3 SAS storage array.

 

I am working on some basic alerts so we know when something is wrong with the box.  My initial thinking was to use SNMP and monitor "Overall Unit Status:".   

 

The issue is that after I pulled a drive and my hot spare started rebuilding the output of "Overall Unit Status" is still OK.  I tested pulling the power from one of the power supplies and this caused "Overall Unit Status:" to report error which is great.

 

The array is in a degraded state, why in the world would the "Overall Unit Status:" still report "OK"?  I see pulling a drive generated a "warning" type of alert, were as when I pulled one power supply it generated a "error" type of alert.  Any reason behind any of this?  I would think a drive going missing or dieing would be an error and not just a warning.

 

Maybe there is a better way of doing this, or a better oid to walk.  I appreciate the input! 

Occasional Visitor
adamb86
Posts: 2
Registered: ‎01-15-2014
Message 2 of 2 (385 Views)

Re: HP P2000 G3 SNMP Alerts

Also, could anyone confirm the various outputs which this OID can output.  I am guessing its "OK" "Error" or "Critical"

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.