4/32 SAN Switch Power Pack Disabled Role (115 Views)
Reply
Regular Advisor
Emad Omar
Posts: 111
Registered: ‎09-06-2004
Message 1 of 2 (115 Views)

4/32 SAN Switch Power Pack Disabled Role

Hi,

 

I have a strange issue with two SAN Switches 4/32 Power Pack, with FOS v6.2.2f.

When I powered on I found both of them are Disabled. I issued command switchenable, then they became enabled as normal.

But when I rebooted or powered off both of them, the role became disabled again on both switches.

I assumed this is related to firmware, so I updated one of them to v6.4.3e (the latest) but I got the same issue.

 

Please advise and help.

Honored Contributor
Sheldon Smith
Posts: 913
Registered: ‎07-27-2003
Message 2 of 2 (109 Views)

Re: 4/32 SAN Switch Power Pack Disabled Role

Take a look at the "switchCfgPersistentDisable and switchCfgPersistentEnable" commands. 

 

 

Note: While I work for HP, all of my comments (whether noted or not), are my own and are not any official representation of the company.

----------

If my post was useful, click on my KUDOS! "White Star" !

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.