do we need to restart SAN switch as we change networking connection to it? (127 Views)
Reply
Super Advisor
Hanry Zhou
Posts: 1,167
Registered: ‎01-11-2002
Message 1 of 2 (127 Views)
Accepted Solution

do we need to restart SAN switch as we change networking connection to it?

We need to make the change on network switch to the brocade SAN switch. All settings, including IP address will be all the same. Does that require to reboot the SAN switch? or is there any command I need to run on SAN switch to pick up the connection?

 

Thanks for your advice!

none
Please use plain text.
Acclaimed Contributor
Torsten.
Posts: 23,212
Registered: ‎10-02-2001
Message 2 of 2 (122 Views)

Re: do we need to restart SAN switch as we change networking connection to it?

No. IMHO you just need to unplug/plug the cable.

Hope this helps!
Regards
Torsten.

__________________________________________________

There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________

No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! star in the left column!   
Please use plain text.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation