Help Specifying P2000 G3 10GbE iSCSI MSA (209 Views)
Reply
Occasional Contributor
stewea
Posts: 6
Registered: ‎11-10-2013
Message 1 of 1 (209 Views)

Help Specifying P2000 G3 10GbE iSCSI MSA

Hi,

 

I'm trying to spec P2000 G3 10GbE iSCSI MSA (AW597B) but I'm a bit confused with the 10GbE iSCSI on the controllers.

 

I'm looking to connect it to the core switch which is going to be a HP 5406zl Switch (J9866A) with the following modules.

HP 8-port 10GbE SFP+ v2 zl Module (J9538A)
HP 8-port 10GBASE-T v2 zl Module (J9546A)

 

So it will actually have 2x  8-port 10GbE SFP and 2x  8-port 10GBASE-T.

 

Do I need a special SFP+ cable to go from the controllers to the 8-port 10GbE SFP+ v2 zl module on the switch?

 

I was then planning on going from the 8-port 10GBASE-T v2 zl module to the servers (709943-421) which have a two port 10Gb 533FLR-T FlexFabric adapter. I was also going to put in a 10Gb 2-port 530T Adapter (656596-B21) into each server.

 

So I was going to split the iSCSI and DATA through both the onboard NICs and the PCIe for redundancy.

 

Any advice would be greatly recieved.

 

Steve

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.