DL380 G3 Cluster Firmware Upgrade (148 Views)
Reply
Advisor
Technical Services_1
Posts: 38
Registered: ‎08-14-1997
Message 1 of 4 (148 Views)

DL380 G3 Cluster Firmware Upgrade

Hi there.

I'm looking to upgrade the firmware on a DL380G3 Cluster. I've downloaded the Proliant Firmware CD and was going to run this against each on the servers and upgrade the BIOS, the Smart Array Firmware and the Disk firmware as well.

Is this the correct way to go about this procedure?

Can someone confirm which is the best way to upgrade the servers / cards and disks firmware please.


Thanks very much,


Please use plain text.
Occasional Visitor
Gwendolyn McIntyre
Posts: 1
Registered: ‎01-23-2004
Message 2 of 4 (148 Views)

Re: DL380 G3 Cluster Firmware Upgrade

You'll need to boot the cluster from the CDROM. Once you do, you should be able to use the Online ROM Flash Component Utility that is (or should be) on the disk to update the cluster.

Gwen

.
Please use plain text.
Respected Contributor
Ruslan
Posts: 313
Registered: ‎08-01-2005
Message 3 of 4 (148 Views)

Re: DL380 G3 Cluster Firmware Upgrade

Booting form CD, you prevent any changes on OS and cluster environment, therefore you must prefer this way. Shutdown both nodes, update firmware on each, then power off both servers and storage (MSA500?). Turn on storage and one node. When cluster services started succesfully (check via cluadmin), power on a second node
Please use plain text.
Advisor
Technical Services_1
Posts: 38
Registered: ‎08-14-1997
Message 4 of 4 (148 Views)

Re: DL380 G3 Cluster Firmware Upgrade

Excellent response - thanks very much.

Worked prefectly.
Please use plain text.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation