SA Multimesh (172 Views)
Reply
Occasional Contributor
Akshatha_1
Posts: 10
Registered: ‎10-06-2009
Message 1 of 4 (172 Views)
Accepted Solution

SA Multimesh

Hello,

 

While installing SA multimesh do we have run Upload software content binary in subsequent core.

 

Regards,

Akshatha

Frequent Advisor
Probir
Posts: 48
Registered: ‎11-09-2011
Message 2 of 4 (157 Views)

Re: SA Multimesh

I don't think so. Its sufficient to upload at the primary core. For detailed info, you can refer to the SA Advanced Installation guide.

Advisor
pkernan
Posts: 14
Registered: ‎06-02-2012
Message 3 of 4 (150 Views)

Re: SA Multimesh

You only need to upload it once via the Primary Core.  The same goes for when you apply a CORD Patch and you the upload for that updated content.

 

Thanks

pk

-------------------------------------------
Riverturn, Inc.
We design, deploy and support Automated Data Centers.

Check out our new website at http://www.riverturn.com for what we can do for you or for more expert advice on Automation.
Frequent Advisor
AntsInPants
Posts: 42
Registered: ‎06-10-2011
Message 4 of 4 (145 Views)

Re: SA Multimesh

Also,

 

Be careful to run content packs in correct sequence, the latest available agent installer is identified by its create/modify time and not the version number. Means that your mesh might think .88 is newer than .132 if you introduced them to the mesh in the wrong order.

 

BrA

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.