using parameters in QC test scripts (523 Views)
Occasional Contributor
Posts: 3
Registered: ‎04-26-2011
Message 1 of 1 (523 Views)

using parameters in QC test scripts

When I use parameters in QC test scripts, and run the script, assign an actual value to parameters at start of script,when I get to that step in script the parameter is replaced with the following:
Sales Office: <3333>
If I go into script though in test plan and "touch" the step with parameter and then save it, move it to test lab and then execute script, now when I get to that step the parameter displays:
Sales Office: <3333> (which is acceptable)
So how do I get the HTML to go away without having to edit each test step with a paramter in QC
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.