RTM (91 Views)
Reply
Occasional Visitor
Manchoc
Posts: 1
Registered: ‎05-02-2014
Message 1 of 1 (91 Views)

RTM

Team

 

The Requirement Traceability option shows the last run execution status. If I had pulled 10 test cases which was ran in a previous test set and only 3 of them are executed in the current test set, then the requirement traceability will have the status for 10 test cases (3 current test set status and 7 previous test set status). Is there an option by which the requirement traceability shows the test case status in the latest build. For example, if I am pulling 10 test cases of 20 to a new test set, then the status for the 10 should be changed to No Run. 

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.